Breadcrumbs

  1. Forum
  3. DIscussions
  5. Tech Help
  7. General
  9. Prop and Spinners

Prop and Spinners

  • Gene Hershey
23 Jul 2019 21:47 #1 by Gene Hershey
Replied by Gene Hershey on topic Prop and Spinners
I had the same problem with my plane. I changed all engine mount rubber bushings (8 pieces from Skyport), and now I have almost 1/2" clearance.

Please Log in or Create an account to join the conversation.

  • Scott Jeffers
  • Topic Author
06 Jun 2019 16:46 #2 by Scott Jeffers
Replied by Scott Jeffers on topic Prop and Spinners
I have a clearance issue between the back plate and nose bowl.
Cannot shave back of plate off any.

Please Log in or Create an account to join the conversation.

More
06 Jun 2019 16:34 #3 by Larry Snyder
Replied by Larry Snyder on topic Prop and Spinners
I have to ask. Why replace the nice Ercoupe spinner with a skullcap?

Please Log in or Create an account to join the conversation.

  • Scott Jeffers
  • Topic Author
06 Jun 2019 14:35 #4 by Scott Jeffers
Prop and Spinners was created by Scott Jeffers
I have a Univair Spinner Assembly on my plane currently. I have a SKULL CAP I want to install in place of it.
The prop has six counterbores where spacers go to align the back spinner plate. My question...do these spacers need to be installed when I replace this spinner with the SKULL CAP or does the prop mount up flush and tight?
Thanks for any help.
Scott

Please Log in or Create an account to join the conversation.

  1. Forum
  3. DIscussions
  5. Tech Help
  7. General
  9. Prop and Spinners
Time to create page: 0.055 seconds
Powered by Kunena Forum