Control Wheel’s on Erco 415-D possible?

Yes unless shafts were cut. Some yokes are deeper so they would cut the shafts. Yokes are usually bolted on so you may have to large holes you may need new shafts also.

I believe you will need the wheels and also control shafts that are a different length, but the real resource for this is

Precision Services Inc.
803-360-2061 no calls after 10PM Eastern
This email address is being protected from spambots. You need JavaScript enabled to view it.

Good day everybody,

I recently owned a 1947 Erco 415-D.
Serial Number is 4737.
Is it possible to exchange the two Yooke's for two steering wheels?
(The "DELUXE CONTROL WHEEL" from Univair only goes up to SN 4423)

Thank you for your answers!
Best regards
Torsten